Price List

This level would be your basic field strip but the primary parts would be sonic cleaned and re-oiled.  All other parts will be hand scrubbed, fouling removed and lightly oiled.

Everything included under field cleaning but detailed strip of the slide (handguns) or bolt (rifles)  is included as well as grips removed to deeper clean when applicable (i.e.- 1911, Sig 220-229, etc)

Everything of detail cleaning but beyond!  This takes your firearm down to pins and springs like it was prior to assembly.  At this level all safety and normal wear parts are evaluated for replacement

Fill in engraved letters / scribing with gold dust to enhance appearance

Clean up trigger pull- reduce creep and smooth pull which ultimately lowers pull 

Installation of night sights into handgun slide (No fee if you purchased the sights through us)

Proper installation of your aftermarket muzzle device = timed properly against barrel shoulder using no "jam nut"

Properly bed your scope base, mount, align/ lap the scope rings and laser bore sight*

Drill and tap holes to mount your scope base(s).  Priced as estimate of 1.5hr labor charge.  Scope mounting and bore sighting included.

Most repairs can be completed within one hour time frame but every repair varies in depth 

      -Minimum bench fee of $30

Patterns  (Multicam, digital, woodland, etc) Add $40 per color beyond 3

Complete strip, sandblast, prep and coating of the slide and frame parts 

    - No cleaning or repair of internal parts removed

    - Sights MUST be removed = return to original zero not guaranteed

Patterns or beaten, used, tattered look = Add $25 per color beyond 3

Disassembly of your rifle to a  barrelled action, sandblasting , prep, coating and reassembly

Installation of your barrel into your slide

Total disassembly of firearm, sharp corners of slide and frame rounded off for smooth draw and re-holstering

  - Solid single color of cerakote included, $50 additional for extra colors / patterns

Opening the ejection port and flaring of lower rear on mill machine

The lower corner of butt frame rounded to improve CCW 

     - Cost of mainspring housing and grips extra

Checkering of grip area below the trigger guard. A time-intensive project but adds much beter grip to front of magazine well.  Checkering cut by hand

Beavertail grip, safety install, trigger swap, trigger guard relief, etc

Threads turned on lathe concentric to bore within .0001in straightness 

Removal of factory handle knob, arm threaded and knob installed

         - Your replacement knob should be delivered with bolt for work

Complete disassembly of action from barrel, bolt face squared, lugs squared, bolt head squared, receiver face squared, threads squared, recoil lug squared and barrel shoulder squared.  This all makes the chamber and bore directly on the same line as the receiver bolt raceway and action.  This process removes all torque and forces acting against natural point of aim and therefore greatly improves accuracy.   

Pinning gas block, opening magazine well, cutting dovetails, etc